This is a high strength leaded silicon manganese bronze with typically good bearing qualities. This alloy maintains high impact resistance with excellent machinability making it well suited for clutch bearings, shaft bushings, sleeve bearings, thrust bearings, pump parts, drive shafts, bearing pins, wear plates, gears and cams. Resists squashing out under high loads and extreme wear applications.
Typical Uses for C67300 Manganese Bronze:
Typical Applications
FASTENERS: Fasteners, Lead Screw Nuts
INDUSTRIAL: Gears and Cams, Wear Plates, Bushings, Seal Rings, Idler Pins, Piston Heads, Brearing Pins, Thrust Bearings, Sleeve Bearings, Propeller Shafts, Shaft Bushings, Clutch Bearings, Drive Shafts, Spindles, Pump Parts, Bearings
MARINE: Hardware, Valve Seats
OTHER: Connecting Rods
Sizes Available
SOLID BAR: 1/4" - 4" diameter in extruded & drawn condition
SOLID BAR: 4 1/4" - 16" diameter in cast & Turned condition
HOLLOW BAR: in the above O.D. size ranges available upon request
Density: .30 lb/in3 at 68 F
-
-
-
*
-
-
*
-
+86-18861825505
-
+86-18861825505
-
kate@xxs-specialsteel.com
-
